Use and Care Manual

VAPORETTO GO

ENGLISH

STORING THE DEVICE

• Store the unit by clip-

ping the end of the ex-

tension tubes into the

generator as shown he-

re.

CARE OF YOUR APPLIANCE

• Before attempting any maintenance

operation, make sure to always disconnect

the appliance from the electrical outlet.

• We recommend that the bristles of the brushes

are allowed to cool down in their normal

position after use, so as to avoid any mis-

shaping.

• To clean the body of the appliance, simply use

a moist cloth.

Regularly check the status of the red gasket lo-

cated in the moulded plug (1F). If necessary, re-

place it with the appropriate spare part (17) as

below .

- Remove the broken / damaged red gasket.

- Insert the new one. Put it on the steam nozzle

and push it until it rests in the groove.

- Lubricate the gasket with some vegetable oil.

TROUBLESHOOTING

PROBLEM SOLUTION

ON lamp (D) off Check that the plug is properly connected to the mains socket.

Ensure that the appliance has been turned on using the ON/OFF swit-

ch (C).

ON lamp (D) on but no steam

is delivered

Wait for the Steam pressure indicator lamp (E) to turn on (approx. 10

minutes). If even once the lamp (D) is on, steam is still not delivered,

there is no water in the boiler. Fill according to the instructions given in

the manual.

The safety cap cannot be un-

screwed

Ensure the machine is off and disconnected from the power supply

and enable the steam control lever (1A) on the steam sprayer (1C) un-

til the steam flow ceases (paragraph “SAFETY CAP / SHORTAGE OF

WATER”)

If the problem persists, unscrew the cap at the same time as applying

gentle pressure with fingers to the cap pin (see fig. A)

Fig. A

VAPORETTO GO - NA - 1U03:FEV 1000-950.qxd 26/03/2014 17.21 Pagina 13