Operation Manual

9. TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
If water comes out from
the Iron soleplate in-
stead of steam.
The optimal settings for
ironing have been not
reached.
Check that the lights are off so that
the temperature and the pressure
have reached the right levels.
The temperature knob
on the iron is set at the
minimum value.
Adjust the temperature knob on
the iron to the medium/maximum
vaue.
The boiler has been
overfilled.
Push the steam button on the Iron
(directing the steam flow on to a
cloth) till steam comes out from
the holes of the Iron soleplate.
Steam does not come
out from the Iron sole-
plate
No power / On-Off swit-
ch is off
Check that the power is on and
that the On/Off switch is pressed.
No water in the boiler.
Check if there is still water in the
boiler and proceed as described in
chapter 6.
Little steam comes from
the Iron soleplate.
Only for Vaporella
515_PRO The steam re-
gulation knob is set at
the minimum value.
Only for Vaporella 515_PRO Increa-
se the steam flow by adjusting the
steam regulation knob to the me-
dium/maximum value (9).
The steam is very dry, so
is barely visible, but is
present and effective.
This is normal especially in particu-
lar environmental conditions.
Some water drops are
present on the fabric.
The cover used on the
Ironing board is wet sin-
ce it cannot withstand
the power of the steam
station.
Check that the Ironing board is sui-
table (ironing board with grid that
prevents condensation).
If problems persist or are not listed above, please contact a Polti Authorised Service Cen-
tre (www.polti.com for the updated list) or contact Customer Services.
ENGLISH
| 27 |
PRELIMINARE VL 505 PRO - 507 PRO - 515 PRO - M0S10674 - 2PP11_7:FEV 1000-950.qxd 10/12/2015 14.26 Pag