PLW8210-Manual

Manual secure subscription
With your system idle and your headset docked, double press the subscription button on
the base. The subscription light will flash red and green. When the subscription light on the
base becomes solid green, the headset and base are subscribed to one another.
Manual over-the-air subscription
1 With your system idle and your headset undocked, double press the subscription button
on the base. The subscription light will flash green and red.
2 Put your headset in subscription mode by holding Volume wheel up for 4 seconds. Upon
release, you hear "Pairing" and the headset LED flashes red/green. When the subscription
light on the base remains solid green, the headset and base are subscribed to one another;
you hear "Pairing successful. Base connected".
NOTE If the base subscription LED goes solid red, after flashing red/green, the subscription
attempt has failed and should be repeated.
End subscription
If the base is in subscription mode and you want to stop the base from searching for a
headset, press the subscription button again. The subscription light will be solid red for
four seconds and then go to its previous state.
Disabling over-the-air subscription
The Savi system ships with the over-the-air headset subscription enabled. In a multi-shift
environment, you may want to disable this mode of subscription.
To disable over-the air subscription, while your system is idle, hold the subscription button
and the base computer button down simultaneously until the base computer button LED
flashes (green for enabled, red for disabled).
Manage settings in Poly Lens Desktop App.
16