Plantronics Voyager Legend CS - User Manual

NOTE If you will be using a standard desk phone set up or a desk phone with an HL10 lifter, continue

below. If you will be using the desk phone with an EHS cable, refer to Desk phone plus EHS cable

section in this guide. For further installation information refer to the EHS Getting Started guide that

came with your EHS cable or at plantronics.com/accessories.

Connect one end of the telephone interface cable to the back of the base.

Disconnect the handset coil cord from the desk phone and re-connect it to the telephone

interface cable junction box.

Connect the remaining end of the telephone interface cable into the open handset port on the

desk phone.

USE

NOTE Your desk phone handset will continue to work; it's just hooked up differently.

NOTE If your phone has a built-in headset port, you should only use the headset port if you will not be

using the HL10 lifter. In this configuration, you must first press both the headset button on your phone

and the call control button on the headset to answer or end calls.

If your desk phone has a volume control set it to mid range.

Look at the bottom of your base and make sure the default settings are correct. Set your desk

phone's volume also.

Set the listening volume dial

and the speaking volume dial to 2.

Set the configuration switch to A.

Set the desk phone volume to mid-range.

Desk phone (standard)

Check configuration and

make a test call