FB3010 flat stacker display ASSEMBLY INSTRUCTIONS IMPORTANT Please read these instructions carefully before you start to assemble this display. Save these instructions for future reference. FB3010 v1.0.
FB2600 - FLAT STACKER BASE WITH CASTERS FB2601 - FLAT STACKER POST FT3200 - FLAT STACKER CLIP BMS1120 - "V" BRACKET RF2554 - BENCH TOP FB2610 - FLAT STACKER BASE W/OUT CASTERS FB2602 - BENCH CARRIER FB2611 - FLAT STACKER EXTENSION
1. PLACE FLAT STACKER POSTS INTO FLAT STACKER BASE & SECURE EACH WITH (2) 5/16" x 3/4" HEX HEAD BOLTS. IMPORTANT: IF YOU HAVE EXTENSIONS, PLACE THE EXTENSIONS AND BENCH CARRIERS ONTO BASE BEFORE INSTALLING "V" BRACKETS. FASTEN BENCH CARRIERS WITH (1) THUMB SCREW. (FIGURE 1) 2. INSERT "V" BRACKETS. (FIGURE 2) 3. PLACE BENCH TOPS ONTO "V" BRACKETS. 4. SECURE BENCH TOPS WITH FLAT STACKER CLIPS.
Do not climb, sit on, or use this product as a ladder due to possible injuries. Do not place or install electrical items on this product. Wet conditions are typical and electrical shock is possible. Do not place this product on a slope that exceeds 10 degrees. If your display does not have casters, do not move this display after product is in place. Damage to display and injuries may occur. If your display does have casters, once in place, lock all casters to prevent movement.