Quick Start Guide

ManualsBrandsPoly ManualsHardwareBT600 network adapter - USB

BT600 Regulatory Compliance Information

North America

FCC regulatory information

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Changes or modiﬁcations not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. This

equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment.

Industry Canada regulatory information

CAN ICES-3 (B)/NMB-3(B)

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may

not cause interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of the device. Le

présent appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de licence. L’exploitation est autorisée aux deux

conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)

l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

This equipment complies with IC radiation exposure limits set forth for

an uncontrolled environment. Cet équipement est conforme aux limites

d’exposition de radiation IC énoncés pour un environnement non contrôlé.

Latin America

IFT warning when product operates under the 2.4GHz or 900MHz band:

Requisitos de la FCC (sección 15) y por la IFT NOM-121-SCTI-2009

Su uso está sujeto a las dos condiciones siguientes:

1. Este dispositivo no puede causar interferencias nocivas.

2. Este dispositivo debe aceptar todas las interferencias recibidas, incluidas

aquellas que puedan causar un funcionamiento no deseado.

Europe

Korea

해당 무선설비는 전파혼신 가능성이 있으므로 인명안전과 관련된

서비스는 할 수 없습니다

Singapore

Complies with

IDA Standards

DA101760

Taiwan

根據NCC低功率管理辦法規定：

第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或

使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；

經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。

前項合法通信，指依電信規定作業之無線電通信。低功率射頻電機須忍

受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Thailand

“

เครื่องโทรคมนาคมและอุปกรณนี

้

มีความสอดคลองตามมาตรฐานทางเทคนิค เลขที่.........

”

“

เครื่องโทรคมนาคมและอุปกรณนี

้

มีความสอดคลองตามขอกําหนดของ กทช

.”

Australia

Phillipines

ESD 1511002C