User Manual

1 To transfer a mobile call from your headset to your mobile phone, press the base mobile phone
button for 3 seconds. The green LED turns off.
2 To transfer a mobile call from your mobile phone to your headset, press the base mobile phone
once. The green LED turns on.
To stream audio from your computer or mobile device, first press the computer or mobile base
Audio button and then play the audio.
There are 2 audio modes: wideband (default) and multimedia (high quality listening).
To optimize your audio quality for your activity, with the system idle, press the headset volume up
button for 4 seconds. The base cycles through the modes with each 4 second press. Also
configurable in Plantronics Hub.
You can limit the amount of nearby conversation that is transmitted during your calls.
Open Plantronics Hub. Go to Settings > General > Close Conversation Limiting. Changes take
effect with the next call. The default is Standard mode which is optimized for most environments.
Simultaneously hold the base buttons of any two of the three base buttons until the LEDs become
solid green to combine the audio of any two devices and create a mini conference call.
You can set up a conference call with 4 additional headsets.
Join Savi headsets automatically
1 While on a call, place the guest headset into the primary user's charge cradle.
The base subscription LED flashes green.
2 The primary user will hear a request "Conference requested." To accept the request, press the
primary user's headset Call button. The base subscription LED turns solid yellow to indicate
conference call mode. View conference call status by going to Plantronics Hub About >
Connections > Conferenced headsets.
Join Savi headsets manually
1 While on a call, press the base subscription button.
The base subscription LED flashes yellow and green.
2 Hold the guest headset's Volume up until the headset LED turns on.
3 The primary user will hear a request "Conference requested." To accept the request, press the
primary user's headset Call button. The base subscription LED turns solid yellow to indicate
conference call mode. View conference call status by going to Plantronics Hub About >
Connections > Conferenced headsets.
Exit a conference call
1 Guest headsets can remain as guests through multiple calls. To remove a guest headset, either
press the guest headset's Call button or dock the primary user's headset in the charge cradle.
Audio streaming
Optimize audio quality
Limit office noise
Mini conference call
Set up a conference call
17