User Manual

With the system idle, change your default phone line/audio channel by pressing and holding for 4
seconds the desired base Audio button until it flashes green 4 times. Customizable in Plantronics
Hub also.
To open an audio channel or get a dial tone, press the headset Call button for 1 second while the
system is idle; the default base Audio button turns green.
• Headset volume Fine-tune your headset volume by adjusting the volume wheel.
• Desk phone volume When you are on a desk phone call and your voice is too quiet/loud, adjust
the microphone volume on the side of the base, located behind the access panel. If your caller's
voice is too loud/quiet on a desk phone call, adjust the base volume dial.
• Base ringtone volume Adjust the base ringtone volume on the left side of the base. This ringtone
alerts you if you are not wearing your headset and a call comes in. There are 4 base ringer
settings: off, low, medium and high.
To mute your headset during on a call, press the headset Mute button. When mute is active, the
base button is red. To unmute, press the headset Call button or the active base Audio button.
When you answer a call, the audio stays with that device (if you answer with the headset, the
audio stays on the headset; answer with your mobile phone, the audio stays on your mobile).
1 To transfer a mobile call from your headset to your mobile phone, press the base mobile phone
button for 3 seconds. The green LED turns off.
2 To transfer a mobile call from your mobile phone to your headset, press the base mobile phone
once. The green LED turns on.
To stream audio from your computer or mobile device, first press the computer or mobile base
Audio button and then play the audio. When streaming audio, the base Bluetooth button is purple.
Active Noise Canceling (ANC) reduces external noise and enhances your music and sound quality.
Your headset ships with ANC on. To turn ANC off, slide the switch away from "ANC."
There are 3 audio modes: wideband stereo (default), wideband (high quality telephony) and
multimedia (high quality listening).
To optimize your audio quality for your activity, with the system idle, press the headset Mute
button for 4 seconds. The base cycles through the modes with each 4 second press. The base
blinks yellow for wideband stereo, green for wideband and red for multimedia mode.
You can limit the amount of nearby conversation that is transmitted during your calls.
Open Plantronics Hub. Go to Settings > General > Close Conversation Limiting. Changes take
effect with the next call. The default is Standard mode which is optimized for most environments.
Simultaneously hold the base buttons of any two of the three base buttons until the LEDs become
solid green to combine the audio of any two devices and create a mini conference call.
You can set up a conference call with 4 additional headsets.
Join Savi 8200 headsets automatically
1
While on a call, place the guest headset into the primary user's charge cradle.
The base subscription LED flashes yellow and green.
2
The primary user will hear a request "Conference requested." To accept the request, press the
primary user's headset Call button. The base subscription LED turns solid yellow to indicate
Change your default
phone line
Get a dial tone
Adjust volume
Mute
Transfer mobile audio
Audio streaming
ANC
Optimize audio quality
Limit office noise
Mini conference call
Set up a conference call
12