User Manual

The headset and base that came in the box are subscribed (connected) to each other. However, if
you wish to use a new headset or need to restore subscription to your current headset, the units
can be subscribed to each other by the following two methods.
With your system idle, docking a headset will automatically subscribe it to the base, making it the
primary headset. The base subscription LED will flash during subscription process and becomes
solid green when the new subscription is established.
1 With your system idle and your headset undocked, press and hold the Subscription button on the
back of the base for 4 seconds. The subscription LED on the display panel will flash.
2 Press and hold the Volume up button on the headset for 4 seconds until the headset LED turns
solid green.
3 When the base subscription LED turns solid green and headset LED turns off, the headset and base
are subscribed to one another.
NOTE If the subscription process times out after 2 minutes or if the subscription process fails, try to
re-subscribe the headset again.
If the base is in subscription mode and you want to stop the base from searching for a headset,
press the subscription button again or place the headset in the charge cradle. The subscription
LED on the base stops flashing and is solid green.
Subscribe headset to base
Automatic secure
subscription
Manual over-the-air
subscription
Ending subscription
10