User Manual

Your Bluetooth USB adapter comes pre-paired to your headset.
1 Turn on your headset and insert the Bluetooth USB adapter into your laptop or PC.
2 The USB adapter LED flashes and then turns solid to indicate the headset is connected to the USB
adapter. If you are wearing your headset you hear “PC connected” to indicate the connection has
been established. When on a call, the LED on the USB adapter flashes blue. When not on a call the
LED is solid.
3 Load Poly Lens Desktop App by visiting poly.com/lens. This allows you to customize your headset
behavior through advanced settings and options.
Pair USB adapter again
Typically, your USB adapter is pre-paired to your headset. In the event that your adapter is
disconnected or bought separately, you will need to pair the adapter to your headset.
1 Insert the high-fidelity Bluetooth USB adapter into your laptop or computer and wait for your
computer to recognize it.
2 Put your headset in pair mode.
3 Put your Bluetooth USB adapter into pair mode by selecting "Pair" in Poly Lens App. Your adapter
flashes red and blue.
Pairing is successful when you hear "pairing successful" and "PC connected" and the Bluetooth
USB adapter LED is solid.
1 To put your headset in pair mode, slide and hold the Power
switch away from the off position
until you hear "pairing" and the headset LEDs flash red and blue.
Poly VFOCUS2
Series
:02
“Pairing”
Blutooth
Headphones
Computer
Camera
Blutooth
“Pairing successful,
phone connected”
Blutooth
2
Activate Bluetooth on your phone and set it to search for new devices.
• iPhone Settings > Bluetooth > On*
• Android Settings > Bluetooth: On > Scan for devices*
NOTE *Menus may vary by device.
3
Select “ Poly VFOCUS2 Series.”
Once successfully paired, you hear “pairing successful” and the headset LEDs stop flashing.
Connect and pair
Connect to PC
Pair to mobile device
5