Users Manual

SME VOIP SYSTEM GUIDE 1.1 14 | P a g e
Proprietary and Confidential
3 Installation of Base stations/Repeater
After planning the network, next is to determine the proper places or location where the relevant Base stations will be
installed. Therefore, we briefly describe how to install the Base station in this chapter.
3.1 Package – Contents/Damage Inspection
Before Package Is Opened:
Examine the shipping package for evidence of physical damage or mishandling prior to opening. If there is a proof of
mishandling prior to opening, you must report it to the relevant support center of the regional representative or
operator.
Contents of Package:
Make sure all relevant components are available in the package before proceeding to the next step.
Every shipped base unit package/box contains the following items:
 2 x mounting screws and 2 x Anchors
 1 x Plastic Wall mount
 Base unit
There is a possibility of using the device in a standalone mode via the power cable (without PoE).
Damage Inspection:
The following are the recommended procedure for you to use for inspection:
1. Examine all relevant components for damage.
2. Make a “defective on arrival – DOA” report or RMA to the operator. Do not move the shipping carton until
the operator has examined it. If possible, send pictures of the damage. The operator/regional representative
will initiate the necessary procedure to process this RMA. They will guide the network administrator on how
to return the damaged package if necessary.
3. If no damage is found, then unwrap all the components and dispose of empty package/carton(s) in
accordance with country specific environmental regulations.