Users Manual

SME VOIP SYSTEM GUIDE 1.1 19 | P a g e
Proprietary and Confidential
4 Making Handset Ready
In this chapter, we briefly describe how to prepare the handset for use, install, insert and charge new batteries. Please
refer to an accompanying Handset User Guide for more information of the features available in the Handset.
4.1 Package – Contents/Damage Inspection
Before Package Is Opened:
Examine the shipping package for evidence of physical damage or mishandling prior to opening. If there is a proof of
mishandling prior to opening, you must report it to the relevant support center of the regional representative or
operator.
Contents of Package:
Make sure all relevant components are available in the package before proceeding to the next step.
Every shipped base unit package/box contains the following items:
 2 x mounting screws and 2 x Anchors
 1 x Handset hook
 1 x A/C Adaptor
 1 x Battery
 1 x charger
 1 x Handset Unit, 1 x Battery cover
Damage Inspection:
The following are the recommended procedure for you to use for inspection:
1. Examine all relevant components for damage.
2. Make a “defective on arrival – DOA” report or RMA to the operator. Do not move the shipping carton until
the operator has examined it. The operator/regional representative will initiate the necessary procedure to
process this RMA. They will guide the network administrator on how to return the damaged package if
necessary.
3. If no damage is found, then unwrap all the components and dispose of empty package/carton(s) in
accordance with country specific environmental regulations.
4.2 Before Using the Phone
Here are the pre-cautions users should read before using the Handset:
Installing the Battery
1. Never dispose battery in fires, otherwise it will explode.
2. Never replace the batteries in potentially explosive environments, e.g. close to inflammable liquids/ gases.
3. ONLY use approved batteries and chargers from the vendor or operator.
4. Do not disassemble, customize, or short circuit the batter