Cordless Telephone User Manual

KIRK System 500 2G4 - Technical Guide, 14090000 Version 2
1–2
• Press the ”menu” key.
• Press the > key once.
• The menu must now show ”EXT. Service”
• Press the ✓ key. The menu will now show ”Clip Stack ”
• Press the < key twice ”Read/Write userdata” appears in the display.
• Then press the ✓key.
The Serial Number of the MASTER handset will now show in the display.
Press the ✓key.
Right after this has been done, the handset will ask for an extension number.
Simply enter the extension number already used by the user of the handset
(Can be the ” old ” extension number used on the corded phone. Or
alternatively any number available in the PABX, in the case the DECT handset
is the only phone used by the user ).
Right after this, the handset will have to be turned off and then on again. In the
display ”system 500” will show.
Referring to this handset as ”MASTER” means that you can configure more
handsets on the system by use of this handset.
Registering Additional Handsets via Master Handset
It is now possible to register additional handsets via your MASTER handset. If
you want to register a handset, the MASTER handset must ”allow” you to do
so.
• Press the ”menu” key.
• Press the > key once.
• The menu must now show ”EXT. Service”
• Press the ✓key. The menu will now show ”Clip Stack ”
• Press the < key twice ”Read/Write userdata” appears in the display.
• Then press the ✓key.
The Serial Number of the MASTER handset will now show in the display. If
you press the > key, you will have 7 additional positions (channel 01 – 07) to
which you can configure handsets.
If the position is empty, the display will show ” _________________”
You can now enter the Serial Number of the new handset (found inside the
handset on the label under the battery). Key in the number in the line
”_______________” shown in the display followed by pressing the ✓key.