Field Verified Configuration Guide Avaya AP-6, AP-7, AP-8 Access Points June 2008 Edition 1725-36046-001 Version G
Field Verified Configuration Guide Trademark Information Notice Polycom® and the logo designs SpectraLink® LinkPlus Link NetLink SVP Are trademarks and registered trademarks of Polycom, Inc. in the United States of America and various countries. All other trademarks used herein are the property of their respective owners. Polycom, Inc. has prepared this document for use by Polycom personnel and customers.
Avaya AP-6, AP-7, AP-8 Access Points Introduction Customers have reported that the WLAN products described in this document operate adequately with SpectraLink Wireless Telephones at their location using the software version listed below. For Field Verified WLAN products, Polycom has not conducted any testing and therefore cannot guarantee interoperability or performance.
Field Verified Configuration Guide Access Point Capacity and Positioning Please refer to the Polycom Deploying Enterprise-Grade Wi-Fi Telephony white paper. This document covers the security, coverage, capacity and QoS considerations necessary for ensuring excellent voice quality with enterprise Wi-Fi networks. For more detailed information on wireless LAN layout, network infrastructure, QoS, security and subnets, please see the Best Practices Guide for Deploying SpectraLink 8020/8030 Wireless Telephones.
Avaya AP-6, AP-7, AP-8 Access Points Access Point Configuration (Up to Version 2.4.11) 1. Connect to the AP via Netscape or Internet Explorer by navigating to the URL http:// (where is the IP address of the AP). 2. Note: these configuration steps can also be accomplished using the SNMP-based Avaya ScanTool program. 3. From the main page, click on the Configure link. 4.
Field Verified Configuration Guide c. Conditional: If you are not using a SpectraLink 8000 SVP Server and intend to use 802.11b/g mode, you must also enter the command: Type set speclinklegacysupport, then press Enter. 11. Restart the AP. The AP is now ready for use with SpectraLink Wireless Telephones. 6 PN: 1725-36046-001_G.
Avaya AP-6, AP-7, AP-8 Access Points Access Point Configuration (Version 2.52) 1. Connect to the AP via Netscape or Internet Explorer by navigating to the URL http:// (where is the IP address of the AP). 2. From the main page, click on the Configure link. 3. To configure WEP settings, obtain the key values from the local network administrator and use the Avaya AP-6, AP-7, or AP-8 User Guide for guidance in programming the encryption settings.
Field Verified Configuration Guide c. A line should come back indicating: speclinklegacysupport enable 10. Restart the AP. The AP is now ready for use with SpectraLink Wireless Telephones. 8 PN: 1725-36046-001_G.
