Field Verified Configuration Guide Airespace Wireless Enterprise Platform – AireOS AS-2000 switch/controller with AP-10xx Access Point June 2008 Edition 1725-36047-001 Version G
Field Verified Configuration Guide Trademark Information Notice Polycom® and the logo designs SpectraLink® LinkPlus Link NetLink SVP Are trademarks and registered trademarks of Polycom, Inc. in the United States of America and various countries. All other trademarks used herein are the property of their respective owners. Polycom, Inc. has prepared this document for use by Polycom personnel and customers.
Airespace Wireless Enterprise Platform—AireOS AS-2000 Switch Controller with AP10-xx Access Point Introduction Customers have reported that the WLAN products described in this document operate adequately with SpectraLink Wireless Telephones at their location using the software version listed below. For Field Verified WLAN products, Polycom has not conducted any testing and therefore cannot guarantee interoperability or performance.
Field Verified Configuration Guide Access Point Capacity and Positioning Please refer to the Polycom Deploying Enterprise-Grade Wi-Fi Telephony white paper. This document covers the security, coverage, capacity and QoS considerations necessary for ensuring excellent voice quality with enterprise Wi-Fi networks. For more detailed information on wireless LAN layout, network infrastructure, QoS, security and subnets, please see the Best Practices Guide for Deploying SpectraLink 8020/8030 Wireless Telephones.
Airespace Wireless Enterprise Platform—AireOS AS-2000 Switch Controller with AP10-xx Access Point Access Point Configuration 1. Connect to the Airespace switch or controller via Netscape or Internet Explorer by navigating to the URL http:// (where is the IP address of the switch or controller). 2. The following table shows additional settings for the 802.11b Network configuration. Navigate to this page by clicking the Wireless tab at the top of the screen and 802.
Field Verified Configuration Guide 6. The following table shows additional settings for the Switch/General configuration. Navigate to this page by clicking the Switch tab at the top of the screen and General in the navigation pane. Parameter Enable multicast support Setting Enabled Criticality Required 7. Click the Apply button to save the changes 8. The following table shows additional settings for the WLAN configuration.