User's Manual

Polycom Bluetooth Module
Integration Note from Corporate compliance to
Engineering.
The Polycom Bluetooth module is designed to be used in Proprietary Polycom set top
videoconferencing products.
Usage notes
The Module is approved using the FCC ‘unlicensed modular transmitter approval’
method. Therefore the module must only be used with the approved antenna board.
Use of another antenna requires re-approval & must be submitted to Polycom
corporate compliance for FCC registration.
All changes to the module must be made through the Polycom electronic change order
process.
All Polycom software written to control this device must use the Radio Power Table
within the module that controls the maximum output power to +4.16 +/- 2 dBm.
When using this module in a Polycom design. The placement of the Antenna and
module must meet the following RF exposure requirements.
A separation distance of at least 20 cm must be maintained between the antenna of
this device and all persons. This Transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter.
The following labelling & user guide information must be used by anyone using this
module. The ECO process will check that these guidelines have been followed.
Labelling:
The following information must be placed on the Regulatory label of the unit that the
module is installed.