Conference Platform Installation Quick Start Guide

Installation Quick Start Guide for
RMX 2000
Basic Setup
Modifying the USB Key Settings
1 Insert the USB Key provided with your system into the PC workstation and double-
click LanConfigUtility.exe to start the utility.
2 Modify the parameters in the utility’s dialog box using the information supplied by
your network administrator.
3 Click OK.
4 Remove the USB Key from the PC.
First-time Power-up and Connection to MCU
1 Insert the USB Key containing the modified IP addresses in the USB port on the
RMX’s back panel.
2 Power the RMX ON.
The parameters in the lan.cfg file are uploaded from the USB key to the RMX’s
memory and applied during the power-up sequence.
System power-up sequence may take up to five minutes.
During the first-time power-up the red ERR LED on the RMX’s front panel remains
ON until both the Management and IP Network Services have been defined.
3 Remove the USB key.
4
5
6 .
Before installing the RMX 2000 and performing the Basic Setup, please read the
General Safety Precautions described in the Polycom RMX 2000 Hardware Guide.
Do not remove the protective plastic caps from LAN1, LAN3 and ShMG ports.
RMX 2000
FAN
STATUS
CNTL
CNTL
MPM+80
MPM+80
PWR
STATUS
PWR
FANS
ERR R DY
ACT
HD
HS
ERR RDY ACT HS
HSERR RDY ACT
MPM/MPM+ Cards & LEDs Fan Drawer
Power Supply Drawer
Control Unit
& LEDs
USB Ports - not for
customer use
Optional CPU &
LEDs
Fan &
Power
Status
LEDs
Front
Panel
LAN 2 Connection
Power
Cable
Off/On
Switch
E1/T1 Connections
(Optional)
Rear
Panel
Enter the IP address of the RMX Control Unit and press Enter.
Enter POLYCOM.
Enter POLYCOM.
Click Login.
Click to connect to Polycom
web site and register the
RMX.
Click Product Registration
and follow the on screen
instructions to obtain the
Product Activation Key.
Enter or paste the Product
Activation Key obtained.
Click OK.
RMX™ 2000
1
DOC2553A