Wireless Server Installation and Configuration Guide

Configuring KIRK Wireless Server 600v3 93
KIRK Wireless Server 600v3 Installation and Configuration Guide
1 Under the Configuration menu, click ETH0, and then click DHCP.
Figure 28 Adm. Page: Configuration/ETH0/DHCP page
2 From the Mode list, select Disabled, and then click OK.
3 Clic
k Reset (under Administration menu) to save your configuration.
4 Under
the Configuration menu, click ETH0, and then click IP.
Note: I
t is necessary to use the ETH0 port when integrating the KWS600v3 on the
local network.
Figure 29 Adm. Page: Configuration/ETH0/IP page
5 In the IP address field, type the new IP address.
The new IP address is now the default address w
hen accessing the KWS600v3.
6 In the Network mask fie
ld, type a new network mask.
7 In the Default gat
eway field, type the IP address of the default gateway.
Contact your system administrator for more
information.
8 Clic
k OK.