User's Manual

Polycom, Inc. 5
Polycom P008 Embedded ISM43341 SIP Application Module – User Guide
FCC IC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
● This device may not cause harmful interference.
● This device must accept any interference received, including interference that may cause undesired
operation.
● Changes or modifications not expressly approved by the party responsible for compliance could void
the users authority to operate the equipment
User Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, can cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
This module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end user has no manual instructions to remove or
install the module.
The module is limited to installation in mobile or fixed applications according to Part 2.1091(b).
Separate approval is required for all other operating configurations, including portable configurations with
respect to Part 2.1093 and different antenna configurations.
The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user
that changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
LE-LAN devices are restricted to indoor operation only in the band 5150MHz to 5250MHz.
FCC / IC Canada Labeling of host device
The modular transmitter is labeled with its own FCC and IC identification number. If the FCC or IC
identification numbers are not visible when the module is installed inside another device, then the outside
of the device into which the module is installed must also display a label referring to the enclosed module.
This exterior label shall use wording as the following: Contains FCC ID: M72-P008 and Contains IC:
1849C-P008.