User's Manual

Polycom, Inc. 6
Polycom P008 Embedded ISM43341 SIP Application Module – User Guide
FCC RF Exposure requirements
The antenna used with this module must be installed to provide a separation distance of at least 20cm from
all persons, and must not transmit simultaneously with any other antenna or transmitter. OEM integrators
and end users must be provided with transmitter operating conditions for satisfying RF exposure
compliance.
Antennas
The 2.4GHz/5GHz radio module PCB antennas are mounted permanently for WiFi/BT operation. Only the
following, or equivalent, are permitted: Unictron Technologies Corp. Chip antenna with 1.4dBi gain at
2.4GHz and 2.3 dBi gain at 5GHz. No external WiFi/BT antennas are allowed.
The NFC antenna loop is connected via a two-pin locking connector. Only the Polycom NFC magnetic wire
loop antenna with 0db gain or equivalent is allowed
Antenna information
The module has been tested and approved for use with only the permanently mounted chip antennas on
the radio PCB. This radio module is not approved for use with external WiFi/BT antennas.
The radio module is approved for NFC use with the plug-in Polycom NFC antenna 2457-69045-003 or
equivalent, typically 1.85uHy for a peak field of 1.85A/m or less at 5mm.
Antenna types
● The onboard WiFi/BT antennas are a dual-band ceramic chip type AA077 from Unictron
Technologies.
● The plug-in NFC antenna is a thin multi-turn loop flex circuit.
Antenna gain
● The WiFi/BT antenna gain varies from 1.4dBi, typical for the 2.4GHz band, and 2.3dBi, typical for the
5GHz band (WiFi only).
● The NFC antenna is a magnetic loop that does not radiate and thus has no gain.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
Safety Information
Canada - Industry Canada (IC)
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of this device.
Note: Obtain authorization for use with unlisted antennas
The use of this module in combination with an antenna that is not listed must be authorized with
respective regulatory agencies.