Installation Instructions
Table Of Contents
- Service Agreements
- Governing Law
- Limitations of Liability
- Polycom Limited Warranty and Limitation Liability
- Exclusions
- Warranty Exclusive
- Safety and Disposal Information
- Compliance Information by Country
- Copyright Information
Polycom G7500 Safety and Regulatory Notice
4
External Power Supplies
This product must only be used with an external power supply of the type and specification provided with
it. Replacement external power supplies can be obtained from the supplier of your Polycom equipment.
PoE Products
Products that are designed to be connected to a Power Over Ethernet source must only be connected to
a IEEE 802.3af compliant power-over-ethernet (PoE) power source or an IEC60950 limited power source.
The power plug, wall socket combination acts as a disconnection device and must be accessible at all
times.
Power Cables
Only use the power cables that are supplied with this product, these are correctly rated for this product.
Installation of the equipment should be carried out by suitably trained people, and must comply with the
appropriate local and national electrical codes.
Plug Acts as Disconnect Device
The socket outlet to which this apparatus is connected must be installed near the equipment and must
always be readily accessible.
La prise électrique à laquelle l’appareil est branché doit être installée près de l’équipement et doit toujours
être facilement accessible
In addition, all POE sources must meet the Limited Power Source requirements of IEC 60950-1:2005
(2nd Edition); Am1:2009 or IEC 60950-1:2005 (2nd Edition); Am1:2009; Am2:2013; and IEC 62368-
1:2014.
En outre, toutes les sources d' entrée doivent obligatoirement répondre aux exigences Source
d'alimentation limitée de la CEI 60950-1: 2005 (2e édition); Am1:2009 ou IEC 60950-1: 2005 (2e édition);
Am1:2009; AM2:2013; and IEC 62368-1:2014.
Operating Ambient Temperatures
● Operating temperature: 32 to 104°F (0 to 40°C)
● Storage temperature: -40 to -140°F (-40 to 60°C)
● Remote control temperature: -4 to 140°F (-20 to 60°C) The manufacturer specified maximum
ambient temperature is 40°C but this must be provided by engineering for each device
Installation Instructions
Installation must be performed in accordance with all relevant national wiring rules.
L’Installation doit être exécutée conformément à tous les règlements nationaux applicable au filage
électrique.