Installation Instructions

Polycom G7500 Safety and Regulatory Notice
7
Compliance Information by Country
USA
Part 15 FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
● This device may not cause harmful interference.
● This device must accept any interference received, including interference that may cause undesired
operation.
Modifications
In accordance with part 15 of the FCC Rules, the user is cautioned that any changes or modifications not
expressly approved by Polycom Inc. could void the user’s authority to operate the equipment.
Class A Digital Device or Peripheral
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Radiation Exposure Statement- Note: Only applicable to radio devices
(P010/P011)
The antenna used for this transmitter must be installed to provide a separation distance of at least 20
centimeters from all persons and must not be co located or operating in conjunction with any other
antenna or transmitter. This portable device with its antenna complies with FCC’s RF radiation exposure
limits set forth for an uncontrolled environment. To maintain compliance, this transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter. FCC registration number: M72
Need Remote Statement and FCC registration number for remote and White camera (Remotec asked to
confirm if M7N-BW7630 covers both remotes).
Remotec to advise if there is an alternative statement for hand held devices
Remote: FCC Identifier: M7N-BW7630
System: FCC Identifier: M72-P011