User's Manual

Programming the SIP Handset Features
PN: 1725-36034-001_C.doc 47
Proxy server commands
Use the following parameters when programming the configuration
files. See the sample configuration files following this table for more
detailed information.
Parameter Value Description Notes
PROXYn_ADDR
xxx.xxx.xxx.xxx:
pppp
or
Proxy address. One
proxy address is
required but
additional proxy
addresses may be
used to register
secondary line
appearances.
n = 1, 2, 3
xxx.xxx.xxx.xxx = IP address
pppp = port (optional, 5060 is
the default)
proxyname:pppp
proxyname = proxy server
name (DHCP only)
PROXYn_DOMAIN Domain name
Domain served by
this proxy server.
n = 1, 2, 3
DOMAIN = [example:
spectralink.com]
Can be omitted if a specific
proxy domain name is not
defined at the proxy server. If
omitted, defaults to the IP
address of the proxy server
(see above)
PROXYn_TYPE Asterisk
SER
Specify the
manufacturer of each
defined proxy server.
Used by the handset to
perform proxy-specific actions
based on known behavior for
specific proxy types. Omit this
parameter if the value is not
Asterisk or SER.
PROXYn_KEYPRESS_2833
*enable
disable
*default (in
example file)
Controls generation
of in-stream
RFC2833 formatted
key press events.
Match what is
required by your
PBX. See RFC2833.
See config file
example for more
information.
n = 1, 2, 3
Must be disabled for OAI.
PROXYn_KEYPRESS_INFO
enable
disable
Controls generation
of SIP INFO requests
to the SIP server for
keypress events.
Normally enabled.
n = 1, 2, 3
Must be enabled for OAI.