User's Manual

Chapter 22-System Configuration Flags
Polycom, Inc. 22-19
Manually Adding and Deleting System Flags
To add a flag:
1 In the System Flags dialog box, click the New Flag ( ) button.
The New Flag dialog box is displayed.
2 In the New Flag field enter the flag name.
3 In the Value field enter the flag value.
The following flags can be manually added to the
MCMS_PARAMETERS tab:
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS
Flag Description
802_1X_CERTIFICATE_MO
DE
Determines whether one TLS certificate is retrieved from the
Certificate Repository for all IP services or if multiple
certificates will be retrieved, one for each IP service. For more
information, see "IEEE 802.1x Authentication” on page 23-42.
Range: ONE_CERTIFICATE, MULTIPLE_CERTIFICATE
Default: ONE_CERTIFICATE.
802_1X_SKIP_CERTIFICAT
E_VALIDATION
If the flag value is:
• YES - The retrieved certificate is not validated against theCA
certificate.
• NO - The retrieved certificate is validated against the
CAcertificate. Validation failure raises an Active Alarm and
isreported in the Ethernet Monitoring dialog box.
For more information, see "IEEE 802.1x Authentication” on
page 23-42.
Range: YES, NO
Default: YES
802_1X_CRL_MODE If the flag value is:
• ENABLED - Forces CRL checking. The system fails the
connection request if the certificate has been revoked or if
there is no CRL.
• OPTIONAL - The system fails the connection request if the
certificate is revoked but does not fail the connection request
if there is no CRL.
• DISABLED - Does not check the CRL and does not fail the
connection request based on the CRL content.
For more information, see "IEEE 802.1x Authentication” on
page 23-42.
Range: ENABLED, OPTIONAL, DISABLED
Default: DISABLED