User's Manual

Chapter 22-System Configuration Flags
Polycom, Inc. 22-23
CP_REGARD_TO_INCOMIN
G_SETUP_RATE
For use in the Avaya Environment.
If set to YES, the Collaboration Server calculates the line rate
for incoming calls in CP conferences, according to the line
rate which is declared by the endpoint in the H.225 setup
message.
If set to NO, the rate is calculated according to the conference
line rate regardless of the rate in the H.225 setup message.
Default: YES.
CPU_BONDING_LINK_MON
ITORING_FREQUENCY
Used when using the MII Monitor for troubleshooting
networks.This flag sets the MII Polling Interval in milliseconds.
A value of zero disables MII monitoring.
Default: 100
CPU_BONDING_MODE Sets the Bonding Mode of the Signalling and Management
network interface controllers.
Mode=6, balance-alb,
(Adaptive Load Balancing) includes balance-tlb, (Transmit
Load Balancing) and balance-rlb (Receive Load Balancing)
for IPV4 traffic. No special switch support is required.
Receive Load Balancing is achieved by ARP negotiation.
Outbound ARP Replies are intercepted and their source
hardware address is overwritten with the unique hardware
address of one of the slaves in the bond. In this way different
peers will use different hardware addresses for the server.
Note: balance-alb is the only supported value. All other
possible values are for troubleshooting purposes only.
Default: balance-alb
Possible values:
• balance-alb
• balance-rr
• active-backup
• balance-xor
• broadcast
• 802.3ad
• balance-tlb
DETECT_SIP_EP_DISCON
NECT _TIMER
The flag value indicates the amount of time in seconds to wait
for an RTCP or RTP message to be received from the
endpoint. When the time that was set in the system flag has
elapsed and no RTCP or RTP audio or video message has
been received on either the audio or the video channel, the
MCU disconnects the SIP endpoint from the conference.
Default: 20 (seconds)
Range: 0 - 300
For more information see "Detecting SIP Endpoint
Disconnection” on page 13-36.
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description