User's Manual

RealPresence Collaboration Server (RMX) 1500/2000/4000 Administrator’s Guide
22-40 Polycom, Inc.
SIP_FAST_UPDATE_INTER
VAL_ENV
Default setting is 0 to prevent the Collaboration Server from
automatically sending an Intra request to all SIP endpoints.
Enter n (where n is any number of seconds other than 0) to let
the Collaboration Server automatically send an Intra request
to all SIP endpoints every n seconds.
It is recommended to set the flag to 0 and modify the
frequency in which the request is sent at the endpoint level
(as defined in the next flag).
SIP_FAST_UPDATE_INTER
VAL_EP
Default setting is 6 to let the Collaboration Server
automatically send an Intra request to Microsoft OC endpoints
only, every 6 seconds.
Enter any other number of seconds to change the frequency
in which the Collaboration Server send the Intra request to
Microsoft OC endpoints only.
Enter 0 to disable this behavior at the endpoint level (not
recommended).
SIP_FREE_VIDEO_RESOU
RCES
For use in Avaya and Microsoft Environments.
When set to NO (required for Avaya and Microsoft
environments), video resources that were allocated to
participants remain allocated to the participants as long as
they are connected to the conference even if the call was
changed to audio only. The system allocates the resources
according to the participant’s endpoint capabilities, with a
minimum of 1 CIF video resource.
Enter YES to enable the system to free the video resources
for allocation to other conference participants. The call
becomes an audio only call and video resources are not
guaranteed to participants if they want to add video again.
Default value in Microsoft environment: NO.
SIP_TCP_PORT_ADDR_ST
RATEGY
Setting the flag to 1 prevents the use of two sockets for one
SIP call - one for inbound traffic, one for outbound traffic. This
is done by inserting port “5060/5061” into the Route[0] header.
Possible values:
• 0 - Inbound traffic on port 5060/5061 outbound traffic on
port 60000
• 1 - Both inbound and outbound traffic on port 5060/5061
Default: 1
SITE_NAME_TRANSPAREN
CY
(MPM+ Only)
In MPM+ Mode this flag is used to enable or disable
transparency (50%) of the Site Name in the video layout.
Set the value of this flag to NO to disable Site Name
Transparency.
Default: YES.
In MPMx Mode this function is controlled using the Profile -
Site Names dialog box.
Note: From Version 8.1, MPM+ Media card is not supported.
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description