Operation Manual

Example Description Status Message
F01MUTEO41
Mute output 4 .
F01MUTEO41
F01MUTEOA0
Unmute output A .
F01MUTEOA0
F01MUTEO72
Toggle mute status of
output 7 .
F01MUTEO7x , where x is either 0 or 1 depending on
the current mute status of the output.
F01MUTEOC?
Query mute status of
output C .
F01MUTEOCx , where x is either 0 or 1 depending on
the current mute status of the output.
F01MUTEO*1
Mute all outputs (1-8, A-
D) .
F01MUTEO*111111111111
F01MUTEO*0
Unmute all outputs (1-8,
A-D) .
F01MUTEO*000000000000
F01MUTEO*111111110000
Mute outputs 1-8 and
unmute outputs A-D.
F01MUTEO*111111110000
F01MUTEO*2
Toggle mute status of all
outputs.
F01MUTEO*abcdefghijkl where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding output. If this
command was sent after the example above, then the
status message would be F01MUTEO*000000001111
.
F01MUTEO*?
Query mute status of all
outputs.
F01MUTEO*abcdefghijkl , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the current
status of the mute on the corresponding output. If this
command was sent after the example above, then the
status message would be F01MUTEO*000000001111
8.98. NC -- Enable Noise Cancellation
This command sets or queries the status of the Noise Cancellation (NC) algorithm on input channels 1-8 .
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on this type
of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will be
restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
F01NC31
Enable NC on input channel 3 .
F01NC31
F01NC10
Disable NC on input channel 1 .
F01NC10
F01NC12
Toggle NC state on input channel 1 .
F01NC1x , where x is 0 or 1 depending on the current
state of NC on input channel 1 .
F01NC2?
Query NC state on input channel 2 .
F01NC2x , where x is 0 or 1 depending on the current
state of NC on the input channel.
F01NC*1
Enable NC on input channels 1-8 .
F01NC*11111111
F01NC*0
Disable NC on all microphone input
channels (1-8) .
F01NC*00000000