Network Router User Manual

Configuration Guide
12 PN: 1725-36061-001_C.doc
This screen shows how to set the cell size and enable the radios via
the
IAP Settings page of the WMI.
1. In the navigation pane, click
IAP Settings.
2. In the
IAP Settings page, click the Enabled check box for each radio
you wish to enable.
3. In the
Cell Size column, select the desired cell size for each radio.
4. Click
Apply to initiate the changes to the Array.
Figure 3: Configuring IAPs
The SpectraLink Wireless Telephones should now be fully operational
and no further changes to the Array’s default settings are required.
However, a few extra steps are required to enable the security
features if so desired. These are explained in the following sections.