SDS

Respiratory Protection: If vapor or mist is generated and the occupational exposure limit is exceeded, use appropriate
NIOSH/MSHA approved self-contained breathing equipment or a full face respirator.
Respirators should be selected by and used following requirements found in OSHA's respirator
standards (29 CFR 1910134). Not required for properly ventilation area.
Ventilation:
Local exhaust and general ventilation is recommended.
Hand Protection: Nitrile Rubbers gloves.
Eye Protection: Wear safety glasses with side shields when handling this product. Wear
additional eye protection such as chemical splash goggles and/or face shield
when the possibility exits for eye contact with splashing or spraying liquid,
or airborne material; Have an eye wash station available.
Skin and Body Protection: Avoid skin contact by wearing chemically resistant gloves and long sleeved
shirt. An apron may be appropriate if splashing can occur.
Physical state: Gel
Color: Gray
Odor: Amine Odor
Weight by gallon: 14 lbs
Solids (% by weight) 100
V.O.C. 0 g/L
Boiling range: 335 F
Melting point: N/E
Density: 1.04
Percent volatile: N/D
Vapor density (air=1): Not Volatile
Vapor pressure (mm Hg): N/E
Evaporation rate: N/A
Water miscibility: <0.1%
Stability: Stable
Incompatibility: Strong oxiders, epoxy resin, and amine mixtures especially when hot.
Hazardous polymerization: Will not occur.
Hazardous decomposition products: Oxides of Carbon and Phenolics under burning conditions
Conditions to avoid: Heat and warm storage
Chemical Name LD50/LC50
Modified Aliphatic Polyamine Not established
Overview: No ecological information available.
Page 4 of 5 www.polygem.com
Section 9: Physical and Chemical Properties
Section 10: Stability and Reactivity
Section 11: Toxicological Information
Section 12: Ecological Information
Section 8: Exposure Control/Personal Protection