User's Manual

TES-63 Source
User manual – version 06/2021
Page 32/46
Polygon Physics SAS au capital social de 72 000 euros - 19, rue de Sassenage - 38600 Fontaine
SIREN 799 584 453 RCS Grenoble - TVA intracommunautaire FR 19 799584453 - APE 2899B
7.2 Commands library
There are 5 main commands to control the electronics unit.
Action
Command
Rack answer
1. Modify a setpoint
<set> <DeviceName> <value><cr>
No error: <cr>
Error: E<code><cr>
<code> is an integer
related to an error type
described in the section
Error list.
2. Modify a setpoint by
doing a ramp
<ramp> <DeviceName> <value><cr>
No error: <cr>
Error: E<code><cr>
<code> is an integer
related to an error type
described in the section
Error list.
3. Get a setpoint
<get> DeviceName<cr>
No error: <cr>
Error: E<code><cr>
<code> is an integer
related to an error type
described in the section
Error list.
4. Measure a value
<meas> <DeviceName><cr>
No error: <cr>
Error: E<code><cr>
<code> is an integer
related to an error type
described in the section
Error list.
5. Switch off the
microcontroller
<stopall><cr>
No error: <cr>
Error: E<code><cr>
<code> is an integer
related to an error type
described in the section
Error list.