Data Sheet

Global Office Locations www.polymaker.com
Shanghai ∙ New York ∙ Utrecht ∙ Tokyo [e-mail]
Testing Geometries
Fig 1
. Tensile testing specimen
Disclaimer
The typical values presented in this data sheet are intended for reference and comparison purposes only. They should not be
used for design specifications or quality control purposes. Actual values may vary significantly with printing conditions. End-
use performance of printed parts depends not only on materials, but also on part design, environmental conditions, printing
conditions, etc. Product specifications are subject to change without notice.
Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/recycling practices of
Polymaker materials for the intended application. Polymaker makes no warranty of any kind, unless announced separately, to
the fitness for any particular use or application. Polymaker shall not be made liable for any damage, injury or loss induced from
the use of Polymaker materials in any particular application.
6.00
80.00
115.00
33.00
R14.00
R25.00
25.00
2.00
Z axis