User guide

8
WARRA
NTY INFORMATION
OUTPUT POWER (max) @ 14.4V / 4Ω / 2
Channel
800 W x 2 CH
Distortion (T.H.D) <0.03%
Signal to Noise Ratio 102dB
Channel Separation 56dB
Input Sensitivity 200mV - 6.0V
LOW PASS FILTER / slope 50 Hz - 5000Hz/12dB
HIGH PASS FILTER / slope 20Hz - 4000Hz/12dB
FUSE RATING 25A x 3
DIMENSION ( L x W x H )in/mm
11”/280mm x
6.7”/170mm x 1.7”/45mm
Nominal Current draw:100W/ 4 OHM 40A
Max current draw 90A
NOTE: Specification & design subject to change without notice for
improvements.
This unit is warranted to be free of defects in material and workmanship for a
period of one year. Warranty is subject to proper installation and operation
within the published specifications. Except as provided below, Poly Planar
will repair or replace, at its discretion, any product returned prepaid to our
facility and determined to be defective. Poly Planar is not liable for
consequential damages
LIMITS OF LIABILITY
Poly Planar warranty does not cover damage occurred in transit, accident,
abuse, misuse, negligence, fire, flood, lightning or unauthorized service. This
warranty assumes no responsibility for damages incurred during installation of
this equipment. This warranty covers normal consumer use only. In no event
shall Poly Planar be liable for special, incidental, or consequential damages.
To obtain service under this warranty, please call Poly-Planar for a RETURN
AUTHORIZATION NUMBER.
poly-planar, inc.
Maryland USA
[phone]
www.polyplanar.com
PRECAUTIONS : READ FIRST!
ME-400D OWNER’S MANUAL
4 CHANNEL CLASS D POWER AMP
•
• The negative battery terminal must be disconnected before any
electrical connections are made.
• If after reading the directions you feel uncomfortable about
installing the amplifier in your vessel, or not equipped or competent
to do so, you should have the amplifier installed by an authorized
installer
• Be sure to choose a location that provides substantial ventilation for
the amplifier. The location chosen should provide at least 2 inch of
clearance above the amplifier for adequate ventilation.
• If the amplifier is to be mounted vertically be sure that it is in a place
where adequate air will flow along the length of its heat sink fins for
cooling.
• NEVER mount the amplifier up side down, this will cause the heat to
rise back into the amplifier causing thermal shutdown or possible
permanent damage.
• Be sure to mount the amplifier to a strong, solid surface which will not
give way under the stress of waves pounding the hull.
• Make sure that the mounting screws will not penetrate through the
hull or into wiring or control cables.
• NEVER ground the speaker leads and NEVER allow the speaker leads
to come in contact with each other. The speaker wire should be at
least 16 gauge or lower.
• NEVER operate the amplifier without the proper power and ground
wire 10 gauge minimum.