Owner manual

1/8”
Hole Diameter
PM2 Installation Guide
Cutout and use as template for drilling
Installation: Find a suitable location making
sure there is clearance for the installed depth.
Use a hole saw or other suitable device to
make a cutout.
Place the unit in the cutout and mark and
drill holes for the mounting screws. If the
panel is too thin or soft for screws use a
stainless screw clips.
Scale= 1:1
Reproduction may change
accuracy
Mounting Depth
80mm
1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel [phone] • Fax [phone] www.polyplanar.com
78.50mm
Cutout
154.5 mm
Cutout