Installation Guide

MOUNTING THE CONTROL PAD AND CAMERA ARM 7
MOUNTING THE CONTROL PAD AND CAMERA ARM
Expect to spend about two hours on this installation.
PLANNING FOR WIRING
CopyCam has three cable connections that converge in the camera
arm, as shown below.
CopyCam wiring can be either:
• against a wall, the typical approach for adapting an existing
facility, or
• within a wall, a potential for new construction or renovation
NOTE:NOTE:
Use the positioning templates provided to assure proper location of
the control pad and camera arm. Failure to do so may result in
inhibited access to the floppy disk drive in the control pad, or in
incomplete copies of the board.
100 Base T Ethernet
Camera arm
Power
adapter
Control pad
with floppy drive
Installguide_RevA_4.fm Page 7 Friday, January 18, 2002 11:05 AM