Installation Guide

8 MOUNTING THE CONTROL PAD AND CAMERA ARM

MOUNTING COPYCAM AGAINST THE WALL

Instructions below provide details for routing cables against the wall.

Refer to “Routing Cables Within the Wall” on page 20 for differences

when installing cables within a wall.

PREPARING TO INSTALL THE CONTROL PAD

ARNING

You must fasten the brackets to the wall so they are secure. CopyCam

mounts to any kind of wall construction. Instructions and wall

fasteners are provided to help you install CopyCam when walls have

metal or wood studs. Be sure to locate studs and use them to drive

mounting screws whenever possible.

Locate and have ready to use:

• control pad positioning template

• control pad

• control pad mounting plate

• 2 #8 x 1.5 drywall screws (provided)

• 4 toggle bolts (provided)

• 4 toggle bolt screws (provided)

• power drill with 1/2 inch (12.5mm)

• power screwdriver with phillips bit, or phillips screwdriver

• pencil

• tape measure (optional)

INSTALLING THE CONTROL PAD MOUNTING PLATE

These instructions guide you through installing CopyCam on a

sheetrock wall. If your wall material is some other substance, such as

concrete or brick, use these instructions as a guideline but install

appropriate anchors to secure the unit to the wall.

Installguide_RevA_4.fm Page 8 Friday, January 18, 2002 11:05 AM