Installation Guide

16 MOUNTING THE CONTROL PAD AND CAMERA ARM
1 At positions that do NOT align with a stud, drill 1/2 inch holes at
the marked positions, using caution not to make the holes too
large, and install a toggle bolt (provided) at each position as
follows:
a Tilt the metal piece so it is flat against the long axis of the
two plastic cords and push it through the 1/2 inch hole.
b Pull back on the toggle bolt to hold the metal piece tight
against the interior of the wall.
c Slide the plastic cap tight against the exterior of the wall.
d Snap off the finger hold and plastic cords flush with the wall.
2 Position the camera arm mounting plate over the mounting
holes.
Installguide_RevA_4.fm Page 16 Friday, January 18, 2002 11:05 AM