Installation Guide

20 MOUNTING THE CONTROL PAD AND CAMERA ARM
ROUTING CABLES WITHIN THE WALL
If you are routing CopyCam cables within the walls, the instructions
for mounting the control pad and camera arm differ in the sequence
that you perform steps. Refer to instructions provided in “Mounting
the Control Pad and Camera Arm” on page 7, but proceed in the
following sequence:
1 Position the control pad and camera arm positioning templates,
marking both the wall anchor positions and the cable exit holes
on the wall. Refer to “To position the control pad mounting
plate:” on page 9 and “To position the camera arm mounting
plate:” on page 15.
2 Use the control pad and camera arm positioning templates to
locate mounting plate exit holes through the wall for cables that
connect the control pad and camera arm. Drill holes and, ideally,
add conduit within the wall between the control pad and camera
arm mounting plate exit holes. (Boxes are not recommended.)
3 Drill a hole in the wall for the power cord to exit near an outlet.
4 Install the control pad mounting plate and camera arm mounting
plate. Refer to “To install the control pad mounting plate:” on
page 9 and “To install the camera arm mounting plate:” on
page 15.
Installguide_RevA_4.fm Page 20 Friday, January 18, 2002 11:05 AM