Installation Guide

MOUNTING THE CONTROL PAD AND CAMERA ARM 21
5 On the back of the control pad, compress the rubber cable
grommet and slide it up so the cable exits toward the wall
instead of toward the floor.
6 Route the RJ14 cable from the back of the control pad into the
wall and up to the camera arm mounting plate exit hole. If
necessary use a fish tape to fish the cable end through the wall
to the camera arm mounting plate exit hole.
7 Leave about 24 inches of cable extending from the camera arm
mounting plate exit hole for later connection to the camera arm,
as shown.
Installguide_RevA_4.fm Page 21 Friday, January 18, 2002 11:05 AM