Installation Guide

28 CALIBRATING COPYCAM
4 Press the button on the control pad. CopyCam recognizes
the calibration sheets and performs an internal calibration
based on the dimensions specified.
5 If your board is wider than 8 feet or taller than 4 feet, mark the
boundary of CopyCam captures by applying the four self-
adhesive border buttons provided, as shown below. These
buttons remind users what part of the board is captured by
CopyCam.
6 Remove the calibration sheets and set them aside in a safe
place, such as tucked into this manual.
NOTE:NOTE:
If CopyCam is installed with a blackboard and if white chalk is
normally used, or if printing exclusively to a black and white printer
such as a network laster printer, consider setting CopyCam to capture
in monochrome to optimize capture quality. Refer to “Using the
Settings Tab” in the CopyCam User’s Guide for information about
capturing in color and monochrome.
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
Corner Calibration Sheet
Place four of these on the writing area. Align each corner of the writing area with this corner on each sheet. Use four pieces of type to ensure that each sheet lies flat.
Corner Calibration Sheet
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
Corner Calibration Sheet
Place four of these on the writing area. Align each corner of the writing area with this corner on each sheet. Use four pieces of type to ensure that each sheet lies flat.
Corner Calibration Sheet
Top Center Calibration Sheet
Center arrow at top of writing area,
under CopyCam arm.
Installguide_RevA_4.fm Page 28 Friday, January 18, 2002 11:05 AM