Installation Guide

36 TROUBLESHOOTING
TECHNICAL SUPPORT
For technical support, contact PolyVision Corporation at:
888-388-0995 or e-mail us at [e-mail]
To order CopyCam parts, contact PolyVision Corporation at:
800-334-4922 from inside the USA, or
503-523-2000 from outside the USA
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense. Modification of this device in any manner not approved by
PolyVision Corporation may void the user's authority to operate it.
“Disk problem” Floppy diskette unformatted
or bad
“Low light” Low light conditions result in
longer capture time
“Hardware problem” Hardware failure: contact
Technical Support
“Calibration needed” Cannot detect borders and
calibration has not been per-
formed
“Calibration done” Calibration is complete and
CopyCam is ready for use
“Calibration problem” Calibration unsuccessful
Installguide_RevA_4.fm Page 36 Friday, January 18, 2002 11:05 AM