Installation Guide

MOUNTING THE CONTROL PAD AND CAMERA ARM 11
NOTE:NOTE:
The control pad mounting plate has feet that hold it slightly away
from the wall.
ROUTING THE CONTROL PAD CABLE
The control pad has one cable:
• RJ14 cable to the camera arm
The cable grommet at the back of the control pad allows for routing
the cable against the wall 0r through the wall. The cable is
configured at the factory for routing against the wall, as shown
below. For routing cables within the wall, refer to “Routing Cables
Within the Wall” on page 20.
Allow the cable to hang from beneath the control pad until you are
ready to route it to the camera arm.
Installguide_RevA_4.fm Page 11 Friday, January 18, 2002 11:05 AM