Installation Guide

18 MOUNTING THE CONTROL PAD AND CAMERA ARM
2 Hang the camera arm from the hook at the bottom of the
mounting plate, as shown below.
3 Locate the cable ends and route them through the exit holes in
the end of the camera arm and up to the cable connectors. Cable
exit holes are available on either side of the camera arm.
4 Plug cables into the cable connectors in the camera arm, as
shown below.
5 Secure the cables to the body of the camera arm (for strain
relief) using the cable ties inside the arm.
6 Replace the camera arm cover and secure it by replacing the
eight lock nuts. Note that the narrow end of the camera arm lid
should be closest to the top of the arm.
LOCKING THE CAMERA ARM IN PLACE
The camera arm tilts up and locks into position for fastening with
three screws (provided).
power brick ethernet
control box
Installguide_RevA_4.fm Page 18 Friday, January 18, 2002 11:05 AM