Installation Guide

MOUNTING THE CONTROL PAD AND CAMERA ARM 19
To lock the camera arm in place:
1 Determine if there is excess cable, and if there is, push it into the
camera arm cavity through the exit hole at the end of the arm.
2 Tilt up the arm, lifting it slightly so that it slides over the pins on
the top of the mounting plate. It should support its own weight
at this point. Be sure cables are not pinched between the arm
and the mounting plate.
3 Fasten the arm in place using the three arm-securing screws
provided. (The larger screw secures the bottom of the arm.)
CONCEALING CABLES
A cable raceway is provided to conceal cables along one edge of the
board.
To conceal cables:
1 Route cables tightly against the edge of the board.
2 Conceal cables using the cable raceway, elbows, and couplers
provided.
3 If necessary, stow any excess cable in the camera arm cavity by
removing the camera arm cover and pulling cable through the
exit hole.
This completes the installation of CopyCam built-in components.
Turn to page 23 to install the printer.
Installguide_RevA_4.fm Page 19 Friday, January 18, 2002 11:05 AM