Installation Guide

22 MOUNTING THE CONTROL PAD AND CAMERA ARM
8 Mount the control pad to its mounting plate. Refer to “Locking
the Control Pad in Place” on page 12.
9 Route power and optional ethernet cables to the camera arm
mounting plate exit hole.
10 Remove the camera arm lid by removing the eight lock nuts.
Refer to “To connect cables in the camera arm:” on page 17.
11 Hang the camera arm from the hook on the mounting plate as
pictured on page 18.
12 Route the cables through the cable exit holes of the camera arm.
13 Connect the three cables in the camera arm and cable tie the
cables in the cavity of the camera arm. Refer to “Cable Routing
and Connections in the Camera Arm” on page 17.
14 Replace the camera arm cover.
15 Tilt up and lock the camera arm in place, using the arm-securing
screws provided. Refer to “Locking the Camera Arm in Place” on
page 18.
Installguide_RevA_4.fm Page 22 Friday, January 18, 2002 11:05 AM