User's Manual

THE COPYCAM WEB SERVER 13
appears, as shown below.
1 Enter your password. The factory default user name is blank and
password is “admin.”
2 Click “OK.”
Use DHCP
Check this box if your LAN uses DHCP protocol. Remove the check
mark if your LAN uses fixed IP addressing. Consult your system
administrator if you are unsure.
IP Address
During configuration, the CopyCam web server IP address is
determined automatically by DHCP or you may assign it here
manually if the “Use DHCP” checkbox is not checked. (Refer to the
CopyCam Installation Guide for information about how to configure
CopyCam the first time.)
Subnet Mask
This network reference is determined automatically by DHCP or you
may assign it manually here if the “Use DHCP” checkbox is not
checked.
Gateway
CopyCam uses this gateway address only when updating firmware
over the Internet. It is determined automatically through DHCP or you
may assign it manually here if the “Use DHCP” checkbox is not
checked.
Userguide_RevA_4.fm Page 13 Friday, January 18, 2002 11:07 AM