Owner's Manual

SEEK Press the up or down SEEK arrow to go to 4. Repeat steps 1-3 for each of four AM and four FM
the next higher or lower station. The sound will be
muted while seelung.
You can also use the
SEEK arrow buttons to scan radio
stations up or down the
AM or FM bands.
To scan stations up the band, press and hold the up
arrow button, then press the ‘down arrow button, then
release both buttons. The radio will
go to the next
station and pause there for a few seconds. It will
continue to scan until you press either
SEEK arrow
button.
To scan stations down the band, press and hold the down
arrow button, then press the up arrow button, then
release both buttons. The radio will go to the next
station and pause there for a few seconds. It will
continue to scan until you press either
SEEK arrow
button.
To Preset Radio Stations
1. Tune in the desired station.
2. Press SET. The word SET will appear on the digital
3. While SET is displayed, press one of the four
screen for five seconds.
pushbuttons.
stations.
Up to three additional stations on each band may be
preset by “pairing” pushbuttons:
1. Tune in the desired station.
2. Press SET, and within five seconds press any two
3. The station can be tuned in when the same two
adjacent pushbuttons at the same time.
pushbuttons are pressed at the same time.
Setting the Tone
BASS:
Slide this lever up to increase bass, or down to
decrease it.
TREBLE: Slide this lever up to increase treble, or down
to decrease it.
If a station is weak or noisy, reduce the
treble.
Adjusting the Speakers
BAL:
The control ring behind the upper knob adjusts
the lefthigbt speaker balance.
FADE: The control ring behind the lower knob adjusts
the fronurear speaker balance.
3-13