Instructions / Assembly

MAXBlue
®
All-in-One
Chlorinating Granules
DIRECTIONS FOR USE:
It is a violation of Federal Law to use this product in any manner inconsistent with its labeling. Read entire label and use strictly in accordance with precautionary
statements, storage, disposal and directions.
Test & balance water prior to use. Adjust pH to 7.2-7.6 and free chlorine to 1-4 ppm. Visit pooltime.com for free water analysis & personalized product and dosage
recommendations.
For best results: Use weekly and apply more product after heavy use, high temperatures, or rain.
To Close Pool: Add 1 lb per 10,000 gallons per above application methods. Next add algaecide per closing directions. Visit pooltime.com for pool closing
instructions.
TEST CHLORINE LEVEL PRIOR TO RE-ENTRY. RE-ENTRY INTO TREATED SWIMMING POOLS IS PROHIBITED ABOVE LEVELS OF 4 PPM CHLORINE DUE TO
RISK OF BODILY INJURY.
IN CASE OF MEDICAL EMERGENCY, CALL 1-877-800-5553.
PHYSICAL OR CHEMICAL HAZARDS: CONTAINS AN OXIDIZING AGENT: DO NOT mix with other products or chemicals. Never add water to product.
Always add product in dry form directly to pool or pool skimmer. Use clean dry utensils. Do not add this product to any dispensing device containing
remnants of any other product. Such use may cause a violent reaction leading to fire or explosion. Contamination with organic matter or other
chemicals will start a chemical reaction and generate heat, hazardous gas, possible fire, and explosion. In case of contamination or decomposition, do
not reseal container. If possible, isolate container in open air or well-ventilated area. Flood area with large volumes of water.
ENVIRONMENTAL HAZARDS: This pesticide is toxic to fish and aquatic organisms.
NOTE: User assumes all responsibility for use not in accordance with directions.
6-in-1 Sanitizer & Shock
APPLICATION METHODS
Always apply in dry form using a designated clean, dry plastic scoop.
Add product to deepest area of pool. Brush visible product until dissolved to
avoid surface damage. Operate filter and pump for at least 2-4 hrs.
Outdoors, in a clean plastic bucket add product to cool water stirring with a
clean plastic or wooden spoon. NEVER add water to product. NEVER add more
than 1 lb of this product to less than 3 gallons of cool water. Do not mix with
other products when pre-dissolving.
WHEN/HOW TO USE
(apply per above application methods)
To Reach 1-4 ppm at Start-Up
Test and repeat application as needed to reach 1-4 ppm of chlorine.
To Sanitize Daily or as needed to maintain 1-4 ppm of chlorine.
To Shock Weekly or if water is cloudy or green.
To Kill Algae
1. Brush algae from pool surfaces prior to use.
2. Apply product at night per above application methods.
3. Repeat after 24 hrs if needed.
Directly to Pool
Pre-dissolve in Water
(recommended for water
under 70°F)
Dosage per
10,000 gallons
4 oz
2-3 oz
1 lb
1 lb–Light algae
2 lb–Heavy algae
3
STEP
SANITIZE
STEP
SHOCK