P/N: ISSC100 Owners manual 2 Wheel & 4 Wheel Suction-Side Poolcleaners Hayward Pool Products 620 Division Street | Elizabeth, NJ 07201 www.Hayward-Pool.com 260630_Hayward_English.
FEATURES SELF ADJUSTING TURBINE VANES All the cleaners have the patented self-adjusting turbines, which maximize the power from the water flow. This turbine is similar to a paddle wheel with blades that are adjustable. This feature allows the cleaner to still move at low suction and low pressure. In addition the folding vanes of the turbine allow for the easy passage of larger debris through the cleaner.
PARTS 2 wheel model 4 wheel model 1x 2x 1x 1x 2x 1x 1x 1x 1x 1x 1x 1x 9x 11x 1x 1x Installing the Cleaner STEP 1; preparing your pool. 1. Manually remove very large and excessive debris from pool ( ie. post storm, spring cleaning/pool opening situations). 2. Perform a backwash, clean your filter, skimmer baskets and pump basket. 3. Make sure your chemical balance is correct. If not, now is the time to correct it. If you chemically shock the pool, wait a day or two before continuing. 4.
STEP 2; connecting the hoses. 1. 20-25” STEP 2 Connecting the hoses . . . 1. Take the Leader Hose (the one with the gray cuff) and attach the float halves 24 inches (60 cm) from the gray end. OR if you have the 2 snap on floats snap them at 20 to 25 inches from the gray cuff. This is the section of hose that attaches to the POOLCLEANER™ in Step 3. (We have already done this step for you). 2. 2. Connect all the hoses (except the Leader Hose). Connect male to female.
202 60CM) 505”( STEP 4; submerging the cleaner. Lower the cleaner into the water. While your pump is running, take the end of the hose with the Adjustable Regulator Valve (if you need it) and hold it against one of the return fittings to expunge all of the air in the hose and the cleaner. OR With the pump turned off, lower the cleaner and then vertically push the hose down into the water until the hose is completely filled with water.
STEP 6; adjusting the cleaner. ADJUSTING WHEEL RPM: For the cleaner to run optimally the revolutions per minute(RPMs) should be between 11 and 14 (Note it will still clean as low as 8 RPM but will NOT climb walls). While the cleaner is running take it by the leader hose so that the cleaner is just below the water. (KEEP THE CLEANER BELOW THE WATER LEVEL or else it will suck air). Now count the number of revolutions made per minute by the RIGHT FRONT WHEEL by using the hump (raised treads) as your marker.
Servicing the Cleaner Removal of Obstructions 3 2 1 Turbine Vanes/Blades The turbine vanes have to be placed in the turbine hub a certain direction. We use the following mnemonic the turbine vanes are like “a wave breaking” toward the front of the cleaner. In the front of the unit the vanes are convex ( like a mountain ) in the back they are concave ( like a valley ). NOTE: The large elliptical end of the vanes is placed into the turbine.
Wheel or Bearing Removal & Replacement 1 2 3 CLICK 5 4 7 6 When the unit is reassembled turn the right front wheel (looking from behind) and make sure everything turns smoothly. Skirt and Inlet Removal & Replacement Inlet Sizes: Small* Medium small pump/variable speed low flow 1 2 Turn the unit upside down and press with both fingers on both sides of the inlet. While pushing down pull up on the inlet. 7 Large average pump normal flow L R Remove the inlet.
Troubleshooting; ALWAYS TURN OFF THE SYSTEM BEFORE PERFORMING ANY REPAIRS. Problem Solution Cleaner doesn’t move or moves too slow. •Check wheel RPM. •Obstruction in the cleaner itself. If there was an obstruction make sure vanes are replaced correctly. •The pump may be turned off or on low speed. •The pump may not be primed. Check for leaks in the system (symptoms--bubbles from the returns ?) Possible other problem or obstruction in the system. Pump impeller blocked? Filter needs backwashing.
Hayward Pool Products Limited Warranty To original purchasers of this equipment, Hayward Pool Products, Inc, warrants these cleaners to be free from defects in materials and workmanship for a period of TWO (2) year from the date of purchase, when used in single family residential applications. The limited warranty excludes damage from freezing, negligence, improper installation, improper use or care or any Acts of God.
Warranty Registration Card DETACH HERE: Fill out bottom portion completely and mail within 10 days of purchase/installation or register online. WARRANTY REGISTRATION CARD Please Print Clearly: Register online at www.haywardnet.