Owner's manual

ManualsBrandsPop & Lock ManualsCarPL8160

Parts Included CHEVY COLORADO / GMC CANYON 2005 & Up

Power Lock

Short Wiring Harness

Wiring Harness

Relay Wiring Cable

Blue Connector Taps

Cable Ties

Tools Required

Philips Screwdriver

10 MM socket

Ratchet

Ratchet Extension

Pliers

Side cutters

Wire strippers

Power Lock Installation

1. Open the tailgate and if applicable, remove the

tailgate bed-liner.

2. Using a philips screwdriver, remove the 4 screws

holding the access panel.

3. Remove the access panel and set aside.

4. Detach the two latch rods from the plastic retainers.

5. Remove the two 10 mm bolts from inside the

tailgate to free the handle assembly.

6. Lift the tailgate in the up position, but do not fully

engage in the latches.

7. While supporting the tailgate with one hand, pull the

bottom of the handle out first (a), then carefully pull

out the handle assembly from the top (b).

8. While the tailgate is in the open position, insert the

POWER LOCK through the access panel opening

and then towards the inside (top of tailgate), leaving

it resting inside to allow room for re-installing the

factory handle.

9. Re-install the factory handle by following step 6 and 7 in reverse order. Please be very careful in this step to not damage the

tailgate paint.

10. Make sure that the POWER LOCK is in the unlocked position, with the Slide Bolt fully

extended.

For Tech Support call: 1-800-342-5911 1 of 2

PL8160

Slide Bolt

Mounting Holes

Actuator

5 7

Mounting Bracket

For the latest instructions please visit www.popandlock.net

12-27-11

Summary of content (3 pages)

PAGE 1
PL8160 Parts Included Power Lock Short Wiring Harness Wiring Harness Relay Wiring Cable Blue Connector Taps Cable Ties CHEVY COLORADO / GMC CANYON 2005 & Up Mounting Bracket Actuator Slide Bolt Tools Required Philips Screwdriver 10 MM socket Ratchet Ratchet Extension Pliers Side cutters Wire strippers Mounting Holes Power Lock Installation 2 4 5 7 1. Open the tailgate and if applicable, remove the tailgate bed-liner. 2. Using a philips screwdriver, remove the 4 screws holding the access panel.
PAGE 2
11.While the tailgate is in the open position, support the factory handle with one hand while positioning the mounting holes of the POWER LOCK over the existing factory holes. 8 12. Thread by hand the two factory bolts back into the handle assembly and Power Lock. Tighten with ratchet and socket. 13. Re-attach the two latch rods to the plastic retainers of the factory handle assembly. Make sure that the plastic retainers snap properly in the closed position. 14.
PAGE 3
LIMITED WARRANTY TERMS AND CONDITIONS (1) Installation. Pop & Lock™, LLC (and Pop & Lock™ Corporation) is not responsible for installing the Pop & Lock™ or for the harm suffered by any person as a result installing it. (2) Warranties. a. Customer acknowledges that it is unreasonable to believe that any device whatever will prevent a theft in the case of every attempt and that the most that can be expected from a so-called anti-theft or security device is that it will deter many thieves. b. POP & LOCK™ LLC.