Installation Guide

1. Verify the identification of the
product purchased before being
installed, the necessary information
appears on the label of each box.
Make sure that the name of the
product, the tone number and mea-
surement are the same in all boxes.
In the case of ceramic pavements
(floors), do not mix identified prod-
ucts with different tone numbers
and measurements.
1.1 In the case of ceramic cover-
ings (walls) make sure that the
name of the product and the
tone number are the same in all
boxes. Do not mix identified
products with different tone
numbers
.
2. It is important that you know the
shade variation of the product that
you will choose, since it will help you
decide the type of environment you
want to obtain with the installation
of ceramic tiles.
3. For flooring installations, mix the
contents of several boxes, identified
with the same number of tone and
measure (Caliber), to obtain the best
appearance. For wall installations,
perform the above process based
only on the tone identified in the
boxes.
4. Do not install if drastic difference
in product dimensions is noticed.
5. In the event that any of the tiles to
be installed has an apparent defect,
please discard and use another tile
of the same shade and caliber.
1. Make sure that the surface where
the products will be installed is
completely clean, free of oils, pow-
ders, paints or impurities, which
inhibit the adhesion of the tile to the
surface. Cleaning can be done with
a broom, pressure washers, spatulas
or sandpaper.
2. Saturate the surface of the
substrate so that it remains moist
during laying, but without puddles.
3. In the event that the installa-
tion is going to be floor on floor,
after cleaning the surface, check
whether damaged or loose tiles
exist and make the necessary repairs
to ensure that no loose or damaged
tile remain in the subfloor.
TILE INSTALLATION
PRODUCT VARIATION
03
STEP
04
STEP
LAYING FLOORS AND WALL TILES
PAGE -
5
5.1
6